Tower Gard 568

 

Features and Highlights:

 

  • Novolac System
  • Flexibilized
  • Solvent Free System
  • 100% Volume Solids
  • Moisture Tolerant System
  • Non-Hazardous Material
  • Excellent Chemical Resistance
  • Physical Resistance

 

Uses:

 

  • Tank coating
  • Underwater application
  • Chemical Tank Coating
  • Anti-corrosive Coating
  • Maintenance Coating
  • Secondary Containment Protection
  • Wastewater Protection
  • Riser repair
  • Splashzone coating
  • Rebuilding of wall loss

 

TOWER-GARD 568 is based on a unique blend of liquid epoxy polymer, toughening resins and aliphatic polyamine curing agents, which is able to displace water from wet surfaces in order to make a permanent bond. The formulation is solvent-free to ensure safety and maximum technical performance. KevlarTM* fibers are incorporated for reinforcement and viscosity management to achieve high application rates-even underwater!

 

TOWER-GARD 568 provides permanent protection usder the most adverse conditions. The formula is uniquely field-friendly and uses advanced low toxicity ingredients. Standard color is Haze Gray which closely matches the color of galvanizing. Shipping is NonHazmat, “Non-Regulated” by USDOT, IATA and IMO.

 

For structural steel and galvanized surfaces in atmospheric service. TOWER-GARD 568 is uniquely tolerant of compromised surfaces. TOWER-GARDS 568 can be applied over all generic types of tightly adherent existing coatings as well as bare steel and galvanizing.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Transportation:

 

Non-regulated by United States - Departmenrt of Transport (USDOT),

International Air Transport Association (IATA) or

International Maritime Organization (IMO)

 

VEHICLE TYPE

PIGMENTATION

THINNER

CLEANER

MIXING RATIO

INDUCTION TIME

POT LIFE

SOLIDS BY VOLUME

SPREADING RATE / GAL

DRY TIME (Dust free)

DRY TIME (Service)

APPLICATION METHOD

VOC

Epoxy, Flexibilizers and Aliphatic amines

Color / anticorrosive / fibrous reinforcement

Not normally required

M.E.K or Lacquer thinner

1.0 / 1.0 v/v

Not required

Approx. 45’ /77°F

100%

80 SQ. ft. / gal @ 20 mils, (508 microns)

4 hours at 77°F

14 hrs. light, 72 hrs. heavy

Brush, roller, painters mitt

Essentially Zero

Products Guideline

Corroserv (M) Sdn Bhd


A25 1st floor, Jalan IM 3/11,

Bandar Indera Mahkota,

25200 Kuantan, Pahang, Malaysia.

 

Tel        : +609-5735623

Fax      : +6095735562

email : admin@corroserv.com.my

Copyrights @ 2015 Corroserv (M) Sdn Bhd

 Downloads

 Technical Data Sheet

 Material Safety Data Sheet

 Application Procedures

 Case Histories
 Test Reports

 

 Training Videos

 Online Store

 Site Map