Monoseal 380

 

Features and Highlights:

 

  • Novolac System
  • Flexibilized
  • Solvent Free System
  • 100% Volume Solids
  • Moisture Tolerant System
  • Non-Hazardous Material
  • Excellent Chemical Resistance
  • Physical Resistance
  • Hydrocarbon Resistance

 

Uses:

 

  • Tank coating
  • Underwater application
  • Chemical Tank Coating
  • Anti-corrosive Coating
  • Maintenance Coating
  • Secondary Containment Protection
  • Wastewater Protection
  • Riser repair
  • Splashzone coating
  • Rebuilding of wall loss

 

GasPruf™ 130 is a unique blend of liquid polymers and proprietary curing agents, which is able to displace MONOSEAL™ 380 laminating resin is designed for use with glass fiber, basalt fiber or carbon fiber fabrics. Its single component, easy to use epoxy resin creates high strength, chemical resistant laminates for reinforcement and leak sealing.

 

Curing is achieved by heating to a temperature of 2500 F+, (1210 C), in some instances this is possible by simply applying to surface which are this hot in normal service. Continuous heat resistance is good to about 4000 F, (2040 C), after which the resin begins to lose significant strength.

 

MONOSEAL™ 380 provides permanent protection under aggressive marine and industrial conditions. The formula is uniquely field-friendly and uses advanced low toxicity ingredients. The standard resin is clear, which cures to amber after exposure to a minimum of 121°C (250°F) + temperatures.

 

Once cured MONOSEAL 380 may be used in service from well below normal ambient temperatures to a practical maximum of 400°F (204°C). Progressive weakening will occur above 400°F (204°C). Although full properties will be restored upon cooling, the system has not been tested above 450°F (232°C).

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Transportation:

 

Non-regulated by United States - Departmenrt of Transport (USDOT),

International Air Transport Association (IATA) or

International Maritime Organization (IMO)

 

VEHICLE TYPE

PIGMENTATION

THINNER

CLEANER

MIXING RATIO

SOLIDS BY VOLUME

RECOMMENDED THICKNESS

CURE SCHEDULE

INDUCTION TIME

APPLICATION METHOD

SHELF LIFE

VOC

FLASH POINT

STORAGE CONDITIONS

 

Epoxy with latent curing agent

None

Not normally required

Lacquer thinner, MEK

NA

100%

NA

4 hours at 266°F (130°C)

NA

Roller, brush or spray

6 Months minimum

Essentially Zero

Over 200°F (93°C)

Normal

 

Products Guideline

Corroserv (M) Sdn Bhd


A25 1st floor, Jalan IM 3/11,

Bandar Indera Mahkota,

25200 Kuantan, Pahang, Malaysia.

 

Tel        : +609-5735623

Fax      : +6095735562

email : admin@corroserv.com.my

Copyrights @ 2015 Corroserv (M) Sdn Bhd

 Downloads

 Technical Data Sheet

 Material Safety Data Sheet

 Application Procedures

 Case Histories
 Test Reports

 

 Training Videos

 Online Store

 Site Map