Gas-Pruf 130

 

Features and Highlights:

 

  • Novolac System
  • Flexibilized
  • Solvent Free System
  • 100% Volume Solids
  • Moisture Tolerant System
  • Non-Hazardous Material
  • Excellent Chemical Resistance
  • Physical Resistance
  • Hydrocarbon Resistance

 

Uses:

 

  • Tank coating
  • Underwater application
  • Chemical Tank Coating
  • Anti-corrosive Coating
  • Maintenance Coating
  • Secondary Containment Protection
  • Wastewater Protection
  • Riser repair
  • Splashzone coating
  • Rebuilding of wall loss

 

GasPruf™ 130 is a unique blend of liquid polymers and proprietary curing agents, which is able to displace water or hydrocarbons such as gasoline, or diesel fuel from wetted surfaces in order to make a permanent bond. The formulation is solvent-free to ensure safety and maximum technical performance. Kevlar™* fibers are incorporated for reinforcement and viscosity management to achieve high application rates -even under hydrocarbon liquids!

 

GasPruf™ 130 is designed for use on pipelines and in tank interiors where high performance epoxy materials must be applied on surfaces wetted with water and/or hydrocarbon fuels. Consult Corroserv to discuss suitability for use in the presence of other organic liquids. The standard color is orange however other colors including White are available in quantity and can be shipped "Non-Regulated" by USDOT, IATA and IMO.

 

ANTICORROSIVE COATING: “Super-Duty” anticorrosive for in-service fuel storage tank interiors and roofs.

 

REPAIR COMPOUND : Patching, leak sealing etc. above and below water or hydrocarbon fuels,and as a interface and load transfer agent for composite repair

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Transportation:

 

Non-regulated by United States - Departmenrt of Transport (USDOT),

International Air Transport Association (IATA) or

International Maritime Organization (IMO)

 

VEHICLE TYPE

PIGMENTATION

THINNER

CLEANER

MIXING RATIO

INDUCTION TIME

POT LIFE

FLASH POINT

SOLIDS BY VOLUME

SPREADING RATE/GAL

DRY TIME, (Dust free)

DRY TIME, (Service)

APPLICATION METHOD

STORAGE CONDITIONS

VOC

Proprietary liquid polymers with curing agent

Color/Inert/fibrous reinforcement

Not required

MEK or lacquer thinner

1.0 : 1.0 by volume

Not required

Approx. 30 MIN at 77°F (25°C)

Over 200°F

100%

40 sq. ft./gal @ 40 mils rec. U/W application rate.

4 hours at 77°F (in air)

14 hrs. light, 72 hrs. heavy

Trowel, “Pool float”, mitts, robotics

Between 35’F – 95’F in original sealed containers

Essentially zero

Products Guideline

Corroserv (M) Sdn Bhd


A25 1st floor, Jalan IM 3/11,

Bandar Indera Mahkota,

25200 Kuantan, Pahang, Malaysia.

 

Tel        : +609-5735623

Fax      : +6095735562

email : admin@corroserv.com.my

Copyrights @ 2015 Corroserv (M) Sdn Bhd

 Downloads

 Technical Data Sheet

 Material Safety Data Sheet

 Application Procedures

 Case Histories
 Test Reports

 

 Training Videos

 Online Store

 Site Map