Corro-Heat 206

 

Features and Highlights:

 

  • Solvent Free System
  • 100% Volume Solids
  • Moisture Tolerant System
  • Excellent Chemical Resistance
  • Physical Resistance

 

Uses:

 

  • Tank coating
  • Underwater application
  • Chemical Tank Coating
  • Anti-corrosive Coating
  • Maintenance Coating
  • Secondary Containment Protection
  • Wastewater Protection
  • Riser repair
  • Splashzone coating
  • Rebuilding of wall loss

 

CORRO-HEAT 206 is a formulated using a combination of liquid epoxy resin and a special high temperature curing agent. A unique feature of this combination is that although it has a high heat distortion temperature it still cures to a hard and “dust-free” condition at normal temperatures. This feature is very useful since it permits convenient handling of laminates prior to final heat curing.

 

CORRO-HEAT 206 has been tested as an external repair composite on a 30” pipe at 356°F, (180°C), at an operating pressure of 300 psi for over four months without failure. Dry testing on steel indicates a temperature resistance up to about 500°F, (260°C).

 

Although the resin hardens at normal ambient temperature it must be heated to a minimum of 150°F/66°C for at least 3 hours for full curing. Maximum Tg, glass transition temperature, is reached after heating to 302°F, (150°C).

 

Surfaces under composites should be free of dust, dirt, oils and moisture. CORRO-HEAT 206 can be applied over properly prepared steel, galvanizing, aluminum and concrete.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

VEHICLE TYPE

PIGMENTATION

COLORS

FINISH

THINNER

CLEANER

MIXING RATIO

INDUCTION TIME

POT LIFE

SOLIDS BY VOLUME

REQ. DRY FILM THICKNESS

SPREADING RATE/GAL

DRY TIME, (Dust free)

DRY TIME, (To Handle)

APPLICATION METHOD

VOC

 

Polyamine cured epoxy resin.

None, (clear resin), or standard green

Amber colored or dark green after curing

Full Gloss

Not normally required

MEK or lacquer thinner

3.70/1.00 by weight, 3.50/1.00 by volume

Not Required

Approx. 1 hr. / 77F, (100 gram mass).

100%

NA

231 cubic inches/gallon

6 hours at 77F

Overnight at 77’F

Brush, Roller, Injection

Essentially zero

 

Products Guideline

Corroserv (M) Sdn Bhd


A25 1st floor, Jalan IM 3/11,

Bandar Indera Mahkota,

25200 Kuantan, Pahang, Malaysia.

 

Tel        : +609-5735623

Fax      : +6095735562

email : admin@corroserv.com.my

Copyrights @ 2015 Corroserv (M) Sdn Bhd

 Downloads

 Technical Data Sheet

 Material Safety Data Sheet

 Application Procedures

 Case Histories
 Test Reports

 

 Training Videos

 Online Store

 Site Map