Corro-Dur 563

 

Features and Highlights:

 

  • Novolac System
  • Flexibilized
  • Solvent Free System
  • 100% Volume Solids
  • Moisture Tolerant System
  • Non-Hazardous Material
  • Excellent Chemical Resistance
  • Physical Resistance

 

Uses:

 

  • Tank coating
  • Underwater application
  • Chemical Tank Coating
  • Anti-corrosive Coating
  • Maintenance Coating
  • Secondary Containment Protection
  • Wastewater Protection
  • Riser repair
  • Splashzone coating
  • Rebuilding of wall loss

 

CORRO-DUR 563 is based on a unique blend of liquid epoxy polymer and aliphatic polyamine curing agents, which is able to displace water from wet surfaces in order to make a permanent bond. The formulation is solvent-free to ensure safety and maximum technical performance. Kevlar™* fibers are incorporated for reinforcement and viscosity management to achieve high application rates -even underwater.

 

CORRO-DUR 563 provides permanent protection under the most adverse conditions. The formula is uniquely fieldfriendly and uses advanced low toxicity ingredients in a high build brushable/rollable product. The sister product Corro Dur 561 is available if a higher viscosity; "light paste" consistency is required. All colors including White are available and can be shipped "Non-Regulated" by USDOT, IATA and IMO.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Transportation:

 

Non-regulated by United States - Departmenrt of Transport (USDOT),

International Air Transport Association (IATA) or

International Maritime Organization (IMO)

 

VEHICLE TYPE

PIGMENTATION

THINNER

CLEANER

MIXING RATIO

INDUCTION TIME

POT LIFE

SOLIDS BY VOLUME

THEO. SPREAD RATE

DRY TIME (TOUCH)

DRY TIME (HARD)

APPLICATION METHOD

SHELF LIFE

VOC

Epoxy / Aliphatic Polyamines

Color / Inert/Fibrous reinforcement

Not required

M.E.K or Lacquer thinner

1 : 1 by volume

Not required

Approx. 20 minutes /77°F (25 o C)

100%

1604 mil/sq.ft./gal, 53.5 sq.ft./gal @ 30 mils (750 microns)

Approx. 4 Hrs/77°F (25oC)

Approx. 3 hrs. light, 24 hrs. heavy service at 77’F (25o C)

Trowel, Straight edged spreader, Mitts, etc.

12 Months minimum

Zero

Products Guideline

Corroserv (M) Sdn Bhd


A25 1st floor, Jalan IM 3/11,

Bandar Indera Mahkota,

25200 Kuantan, Pahang, Malaysia.

 

Tel        : +609-5735623

Fax      : +6095735562

email : admin@corroserv.com.my

Copyrights @ 2015 Corroserv (M) Sdn Bhd

 Downloads

 Technical Data Sheet

 Material Safety Data Sheet

 Application Procedures

 Case Histories
 Test Reports

 

 Training Videos

 Online Store

 Site Map