Corro-Dur 258

 

Features and Highlights:

 

  • Novolac System
  • Flexibilized
  • Solvent Free System
  • 100% Volume Solids
  • Moisture Tolerant System
  • Non-Hazardous Material
  • Excellent Chemical Resistance
  • Physical Resistance

 

Uses:

 

  • Tank coating
  • Underwater application
  • Chemical Tank Coating
  • Anti-corrosive Coating
  • Maintenance Coating
  • Secondary Containment Protection
  • Wastewater Protection

 

CORRO-DUR 258 is formulated for effective field application by brush, roller or plural component heated airless sprayer. The CORRO-DUR 258 formulation is based on a unique resin system which may be applied to damp or wet surfaces. This resin system is toughened with * KevlarÔ fibers to give superior chip resistance and is pigmented with select hard ingredients to further enhance wear resistance.

 

The cured film is glossy with a slight texture resulting from the fiber reinforcement. Related products have been employed for underwater application and have been subjected to both radiation and DBA testing with excellent results. The resin system used has excellent resistance to commodities such as hydrocarbon oils and fuels, mineral acids and alkalies.

 

The solvent - free formulation avoids the objectionable odor and explosion hazards of epoxy solvents. Absence of solvent also assures compliance with all present and proposed air pollution regulations and prevent common service problems caused by shrinkage or water sensitivity of residual entrained solvent residues. Corro-Dur 258 can be applied on surfaces such as steel, concrete, FRP and etc.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Transportation:

 

Non-regulated by United States - Departmenrt of Transport (USDOT),

International Air Transport Association (IATA) or

International Maritime Organization (IMO)

 

VEHICLE TYPE

PIGMENTATION

CLEANER

MIXING RATIO

INDUCTION TIME

POT LIFE

SOLIDS BY VOLUME

REC. DRY THICKNESS

THEO. SPREAD RATE

DRY TIME (TOUCH)

DRY TIME (HARD)

APPLICATION METHOD

SHELF LIFE

VOC

Epoxy / Aliphatic Polyamines

Color / Fibrous reinforcing / Inert extender

M.E.K or Lacquer thinner

5 : 3 by volume

Not required

Approx. 30 minutes /77°F (25°C)

100%

12-24 mils (300 – 600 microns)

3.33 sq.m/l @ 300 microns; 1.67 sq.m/l @ 600 microns

Approx. 4 Hrs / 77°F(25°C)

Approx. 15 Hrs / 77°F (25°C)

Roller

12 Months minimum

Zero

Products Guideline

Corroserv (M) Sdn Bhd


A25 1st floor, Jalan IM 3/11,

Bandar Indera Mahkota,

25200 Kuantan, Pahang, Malaysia.

 

Tel        : +609-5735623

Fax      : +6095735562

email : admin@corroserv.com.my

Copyrights @ 2015 Corroserv (M) Sdn Bhd

 Downloads

 Technical Data Sheet

 Material Safety Data Sheet

 Application Procedures

 Case Histories
 Test Reports

 

 Training Videos

 Online Store

 Site Map