CORRO-CHIME 390 is a solvent-free, elastomeric, chemically resistant sealant with the consistency of soft putty. When fully cured, it resembles tennis ball rubber. Moisture resistant and can be applied to surfaces down to a temperature of 2°C and resistant to ultimate cold surfaces upon curing to a lowest temperature of -60°C.

 

CORRO-CHIME 390 is an extremely adhesive material suitable for application over steel, primed or painted steel or concrete. CORRO-CHIME 390 is designed for applications where a flexible, corrosion resistant seal or expansion joint is required. Especially recommended for exposure to aromatic and aliphatic hydrocarbons, mineral acids, esters and alcohols except methanol.

 

TANK CHIME AREAS: Creates a permanently flexible corrosion resistant seal on the exterior chime surfaces of field storage tanks and similar structures.

 

CONCRETE EXPANSION JOINTS: Use in situations where other joint compounds would

soften or fail by solvent or chemical attack

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Transportation:

 

Non-regulated by United States - Departmenrt of Transport (USDOT),

International Air Transport Association (IATA) or

International Maritime Organization (IMO)

 

Features and Highlights:

 

  • Novolac System
  • Flexibilized
  • Solvent Free System
  • 100% Volume Solids
  • Moisture Tolerant System
  • Non-Hazardous Material
  • Excellent Chemical Resistance
  • Physical Resistance
  • Hydrocarbon Resistance

 

Uses:

 

  • Coating ONLINE onto sweating / cold pipe
  • Tank coating
  • Underwater application
  • Chemical Tank Coating
  • Anti-corrosive Coating
  • Maintenance Coating
  • Secondary Containment Protection
  • Wastewater Protection
  • Riser repair
  • Splashzone coating
  • Rebuilding of wall loss

Corro-Chime 390

VEHICLE TYPE

PIGMENTATION

COLOURS

FINISH

CLEANER

MIXING RATIO

INDUCTION TIME

POT LIFE

THINNER

SOLIDS BY VOLUME

SPREADING RATE/GAL

 

COVERAGE, EXTERIOR CHIME

DRY TIME (TO TOUCH)

APPLICATION METHOD

VOC

FULL CURE

FLASH POINT

Epoxy / polysulfide

Color / Inert

Gray

Medium gloss

MEK or lacquer thinner

Base/Cure :: 1/1 by volume

Not required

Approx. 45’/ 77°F (25°C)

Not normally required

100%

1.4 m2 / litre (57.0 sq.ft / gallon) at 500 microns (20 mils);

0.16 m2 / litre (6.4 sq.ft./gallon) at 6250 microns (250 mils)

6 ft/gallon, 3” foundation lip

4 hours at 77°F (25°C)

Brushes, spreader or heated plural airless spray

Essentially Zero

24 hours

Over 200°F (93.3°C)

Products Guideline

Corroserv (M) Sdn Bhd


A25 1st floor, Jalan IM 3/11,

Bandar Indera Mahkota,

25200 Kuantan, Pahang, Malaysia.

 

Tel        : +609-5735623

Fax      : +6095735562

email : admin@corroserv.com.my

Copyrights @ 2015 Corroserv (M) Sdn Bhd

 Downloads

 Technical Data Sheet

 Material Safety Data Sheet

 Application Procedures

 Case Histories
 Test Reports

 

 Training Videos

 Online Store

 Site Map